よくあるご質問

回答

When you installed a printer driver you need to configure the driver to accommodate installed trays and finisher etc. to the machine. Normally, this setup is automatically set at the installation of a printer driver to accommodate MFP’s optional device configuration. When you unchecked [Auto Configuration] or change the settings, please follow the procedure below.
The following procedure takes BP-70C26 as an example.

You can configure the settings automatically or manually.
Please set up manually if you use IPv6 for a network connection or when Auto Set does not work properly.

• Auto Set
• Manual setting

Procedure for Auto Set

1. Open [Printer Properties].

2. Show Configuration.

Click the [Configuration] tab.

3. Start Auto Configuration.

When you click the [Auto Configuration] button, the setting update begins automatically.

4. Update Machine Image (configuration).

Check each item that automatically updated then click the [OK] button.

Procedure for Manual Setting

1. Open [Printer Properties].

2. Show Configuration.

Click the [Configuration] tab.

3. Configure the Settings for Paper Feeding/ Exit Options etc.

For the settings of Paper Feeding/ Exit Options etc., you should check the installed options by sight.

4. Set Up the Tray(s).

Click the [Set Tray Status] button.

5. Check the Tray Settings on the Touch Panel.

Check the tray settings on the operation panel.
Tap the [Settings] key on the operation panel.

【English】

【日本語】

6. Open [Common Settings] page.

Tap [Common Settings].

【English】

【日本語】

7. Open [Paper Settings] page.

Tap [Paper Settings].

【English】

【日本語】

8. Open the [Paper Tray Settings] Page.

Tap [Paper Tray Settings].

【English】

【日本語】

9. Register the Settings to [Tray Settings].

Looking up all settings information and copy the settings to the tray settings of [Printer Properties].

【English】

【日本語】

10. Complete the Setup.

Click the two [OK] buttons to complete the setup.